|
SANIVITE (Pump Only)
Handles hot water
Fits
in cupboard
Ideal
for dishwasher
Free Shipping
The Sanivite is a gray water pump intended for
utility room sinks, kitchens or laundry rooms. It is designed to
handle very hot temperatures from waste water from dishwashers or
washing machines (washing machine must drain into a laundry tub
first). It fits neatly inside a kitchen cabinet.
The Sanivite is a gray water pump
and is ideally suitable for use in a basement apartment. It will
pump waste water away from a variety of sources, such as a kitchen
sink, laundry sink, clothes washer (indirect via a laundry tub
only), dishwasher, bar sink, etc.
|
SaniVite
The inside of the Sanivite comprises of a
pressure chamber, which starts and stops the unit and the motor,
which drives the pump.
When water is entering the Sanivite a micro switch
in the pressure chamber is activated, which in turn starts the
motor. The motor is sealed for life in an oil filled enclosure. A
spindle drives the impeller, the moving parts therefore are kept to
an absolute minimum. Water enters the chamber and are pumped away
into the sanitary sewer. The pump operates at 10 PSI and pumps the
waste upwards to 12 feet and/or 150 feet horizontally. Once the
water is discharged and the water level in the container goes down,
the micro switch deactivates the unit until water enters the unit
again. A normal operating cycle for Sanivite can be
as short as 2-10 seconds depending upon the discharge pipe run
configuration, power consumption is therefore minimal.
In addition to sinks, Sanivite will also accept and
discharge the waste water from a variety of other sanitary fixtures,
such as; a hand basin, a shower, a bath, a urinal and possibly a
whirlpool. When adding a shower or bathtub, a base will have to be
constructed, made out of 2" x 6" on edge, to allow for the
installation of a P-trap and some gravity flow towards the pump
unit, as it does not suck in water.
The waste water from other sanitary fixtures is discharged into
Sanivite via two 1½-inch inlets, on either side of
the housing. Either one or both inlets can be used as required. The
discharge elbow on top of the Sanivite can be
turned either to the left or to the right, depending on the
discharge installation. The Sanivite may be vented, there is a
1½-inch connection on the top of the unit. The discharge pipe size
may be made from 1-inch material.
The Sanivite is small enough to fit comfortably
inside a kitchen cabinet or vanity or inside the overhang of a
whirlpool. Electrical supply to the Sanivite is
120V, 15 Amp. The system should be connected to a Ground Fault
Circuit Interrupter circuit.
Free Shipping to the
Contiguous United States
|
